NEWS

In hot weather, with the gradual increase of temperature, the high temperature phenomenon in a Raymond mill grinding room has become a concern of many users in high temperature weather. How to make Raymond mill grinding room reach rapid cooling is the most important thing in everyone's mind. Today I am here to introduce you how to avoid the temperature rise of the Raymond mill, and hope to help the majority of users.


The temperature of the grinding chamber of the Raymond mill is increased because the sealing condition of the equipment will continue to decrease after a long period of use, resulting in grease leakage, which not only increases the temperature of the bearing, but also  reduce operational flexibility, so pay attention to the working conditions of super-Ray-grinding, such as bearings, grinding rolls, etc., to regularly quantify the lubrication part to ensure a good working environment of the various parts of the equipment, increase the operation of each part Flexibility, reducing friction between the contact surfaces and extending the life of the equipment, thus avoiding the problem of excessive temperature in the Raymond grinding chamber. According to the working conditions, the ventilation can be appropriately adjusted, that is, the ventilation duct is opened, and the external airflow is connected with the airflow in the grinding chamber, so that the temperature in the grinding chamber is gradually lowered, and the temperature of the grinding chamber of the Raymond mill is prevented from being too high.

The high temperature of the Raymond mill grinding chamber is often caused by small problems being ignored. Therefore, in the process of operating Raymond mill, we must pay attention to our own operation mode, in case of problems and repair in time, in the summer, the Raymond mill is working at high temperature for a long time, it should be stopped in the middle of the road, do not let the machine always exposure, although Can not change the hot climate, you do the following, I believe that the high temperature phenomenon of the Raymond mill grinding chamber can be avoided.

1. In order to make the Raymond mill powder machine normal, the equipment “safe operation system for equipment maintenance” should be established to ensure the long-term safe operation of the Raymond mill, and necessary maintenance tools as well as grease and corresponding accessories.
2. When the grinding roller device of Raymond mill is used for more than 500 hours to replace the grinding roller, the rolling bearings in the roller sleeve must be cleaned, and the damaged parts should be replaced in time. The fueling tool can be used with manual fuel pump and grease gun. .

3. During the use of Raymond mill, there should be fixed personnel responsible for the care. The operator must have a certain level of technology. The Raymond mill must perform the necessary technical training before the installation to understand the principle performance of the Raymond mill and familiar with the operating procedures.
4. After using the Raymond mill for a period of time, it should be repaired. At the same time, the wearing parts such as the grinding roller and the blade should be repaired and replaced. The grinding roller device is connected to the bolt before and after use.