Raymond Mill Maintenance Code
Date：2019-09-12 Views：1488
Raymond mill is widely used in non-metallic mineral grinding processing with Mohs hardness below 7 and humidity below 6% due to its stable performance, excellent quality and stable operation. For the customer, in the course of operation, it is very important to do the normal maintenance and repair work of Raymond Mill. This article is mainly to discuss how to maintain and repair the Raymond Mill, and I hope to help you.
1. In order to make the Raymond mill operate normally, a “safe operation system for equipment maintenance” should be established to ensure the long-term safe operation of the Raymond mill, and necessary maintenance tools as well as grease and corresponding accessories.
2. When the grinding roller device of Raymond mill is used for more than 500 hours to replace the grinding roller, the rolling bearings in the roller sleeve must be cleaned, and the damaged parts should be replaced in time. The fueling tool can be manually pumped.
1. In order to make the Raymond mill operate normally, a “safe operation system for equipment maintenance” should be established to ensure the long-term safe operation of the Raymond mill, and necessary maintenance tools as well as grease and corresponding accessories.
2. When the grinding roller device of Raymond mill is used for more than 500 hours to replace the grinding roller, the rolling bearings in the roller sleeve must be cleaned, and the damaged parts should be replaced in time. The fueling tool can be manually pumped.
3. During the use of Raymond mill, there should be fixed personnel responsible for the care, the operator must have a certain level of technology. The Raymond mill must perform the necessary technical training before the installation to understand the principle performance of the Raymond mill and familiar with the operating procedures.
4. After using the Raymond mill for a period of time, it should be repaired and repaired. At the same time, the wearing parts such as the grinding roller and the blade should be repaired and replaced. The grinding roller device should be carefully checked before and after the use. There is looseness, and the grease is added.
5. The scrapping limit of the grinding roller ring, the remaining minimum wall thickness shall not be less than 10mm.
6. It is strictly forbidden to enter the metal block. If it is found to be taken out immediately, it will damage the grinding roller and the grinding ring, even the center hanger.
7. Air volume adjustment: The air volume control valve located on the air intake pipe of the fan is generally opened to the maximum position, and is adjusted according to the fineness and output requirements.
how about it? Have you inspired me after reading? What actions did you use during the use of the Raymond mill? Develop a good maintenance and repair habit, not only can improve the service life of the equipment, but also improve the quality of the finished product and improve the competitiveness of the enterprise market.
4. After using the Raymond mill for a period of time, it should be repaired and repaired. At the same time, the wearing parts such as the grinding roller and the blade should be repaired and replaced. The grinding roller device should be carefully checked before and after the use. There is looseness, and the grease is added.
5. The scrapping limit of the grinding roller ring, the remaining minimum wall thickness shall not be less than 10mm.
6. It is strictly forbidden to enter the metal block. If it is found to be taken out immediately, it will damage the grinding roller and the grinding ring, even the center hanger.
7. Air volume adjustment: The air volume control valve located on the air intake pipe of the fan is generally opened to the maximum position, and is adjusted according to the fineness and output requirements.
how about it? Have you inspired me after reading? What actions did you use during the use of the Raymond mill? Develop a good maintenance and repair habit, not only can improve the service life of the equipment, but also improve the quality of the finished product and improve the competitiveness of the enterprise market.
